conanthewarrior
Achiever
- Joined
- May 17, 2015
- Messages
- 3,061
Hi people-I was wondering something earlier.
I understand that with the DNA200's nominal voltage of 11.1V, and full charge of 12.6V, and its lowest charge, If I build below 0.4 the highest it hits is 20A.
I notice that with a 80W preheat, and a punch around 6, it hits 17 amps for a fraction of a second then once it hits temp drops to ten or under.
So, is it safe to run my DNA200 just once to test it at its full power-building below 0.4 to make sure I am 5 amps under the 25A fuse blowing.
Say I accidentally had a standard build on there, but the power was near 200W, but above 0.4, what would happen? Would it not fire-or would it fire and the fuse blow?
I am very unlikely to do so-both devices will be used with TC in mind, the hotcig for lower wattage, the Efusion for my drippers and 80-100W max builds/coils that need that power.
I understand under 0.4 I am completely safe, at 12.6V it goes to 0.7 but I would only build lower for two reasons-I would not want to blow the fuse, and I don't fancy 200W at 0.7 lol.
So, really my question is will it not fire, or will the fuse blow?
Thanks people, Conan.
I understand that with the DNA200's nominal voltage of 11.1V, and full charge of 12.6V, and its lowest charge, If I build below 0.4 the highest it hits is 20A.
I notice that with a 80W preheat, and a punch around 6, it hits 17 amps for a fraction of a second then once it hits temp drops to ten or under.
So, is it safe to run my DNA200 just once to test it at its full power-building below 0.4 to make sure I am 5 amps under the 25A fuse blowing.
Say I accidentally had a standard build on there, but the power was near 200W, but above 0.4, what would happen? Would it not fire-or would it fire and the fuse blow?
I am very unlikely to do so-both devices will be used with TC in mind, the hotcig for lower wattage, the Efusion for my drippers and 80-100W max builds/coils that need that power.
I understand under 0.4 I am completely safe, at 12.6V it goes to 0.7 but I would only build lower for two reasons-I would not want to blow the fuse, and I don't fancy 200W at 0.7 lol.
So, really my question is will it not fire, or will the fuse blow?
Thanks people, Conan.