nathanstokes
Postman
- Joined
- Aug 5, 2018
- Messages
- 68
Hey guys.
So, I make my own coils and have been thinking of trying out stainless steel. I've never bothered before, as I don't get any weird tastes from Ni80, and I haven't found thus far any info on the way that resistance changes other than it increases as the metal heats. I'm just kind of curious, though, to see if I prefer the flavour from them.
With RDAs I tend to make 3x28/36 dual aliens, 3mm inner diameter, 5 wraps, ohming out at 0.16 (exception being 0.14 fralians in my Kennedy 25), and then for MTL a 28/46 clapton, with 2.5mm ID, 6 1/2 wraps ohming out at 0.91.
Before someone says, it's fine, just use TC or simple power mode, I vape mostly with single battery tube mods, so looking to figure out what specs I should use that would ohm out roughly at those points once they're heated.
Any advice, knowledge or links would be massively appreciated.
So, I make my own coils and have been thinking of trying out stainless steel. I've never bothered before, as I don't get any weird tastes from Ni80, and I haven't found thus far any info on the way that resistance changes other than it increases as the metal heats. I'm just kind of curious, though, to see if I prefer the flavour from them.
With RDAs I tend to make 3x28/36 dual aliens, 3mm inner diameter, 5 wraps, ohming out at 0.16 (exception being 0.14 fralians in my Kennedy 25), and then for MTL a 28/46 clapton, with 2.5mm ID, 6 1/2 wraps ohming out at 0.91.
Before someone says, it's fine, just use TC or simple power mode, I vape mostly with single battery tube mods, so looking to figure out what specs I should use that would ohm out roughly at those points once they're heated.
Any advice, knowledge or links would be massively appreciated.