What's new

Problem with provari min v2

Luxe02

Initiate
Joined
Dec 25, 2012
Messages
31
Hi all

Just wandering if anyone else has experiences this problem ?

Just picked up a new provari mini v2 yesterday :)

The clearomisers and tanks i have are rated 2+ ohm's
Very often when i start the unit and check ohm for atty etc.... It shows a reading 0.8ohm
I replace for another unit and same thing. Surely the unit should reset itself.

The only way i can get it to work is by removing battery and reinserting, then even the unit which displayed the low ohm reading works.

All my cartsomisers / tanks etc. Have no problems and i use them on other devices.

This is happening a lot and is becoming tiresome :(

Any help would be appreciated.

Regards
Luxe
 
Have you got a different type of atty or carto you could try to see if it reads them properly?
 
Have you got a different type of atty or carto you could try to see if it reads them properly?

Have only got it yesterday.

I have tried with a new viva nova tank a few mins ago and same reading.

Like i mentioned if i remove battery it seems to reset and it works. Then when i turn off and turn on again same low 0.8 reading and not working :( untik battery is removed.

Best
Luxe
 
Also when battery removed and unit reset it gives correct 2.2ohm, but after turning off and on after a while stops with that dreaded o.8 reading.

But strangely not getting any error messages ?

Will go back to retailer on Thursday, but the dreaded wait and i dont think he has anymore of the green led ones :(

Best
Luxe
 
Sounds like its worth getting the seller to give it a check over :)
 
Back
Top Bottom