Separate names with a comma.
Wanting to join the rest of our members? Why not sign up today!
Discussion in 'Rebuildable Mods and Devices' started by StuPot, Jan 9, 2015.
Can you post a piccy of the positive pin mate .mine fits flush on all my mods
If this isn't clear enough let me know and I'll drag the camera out, thanks.
Yep that's wrong.. Try pushing / screwing nearly the whole thing back inside.
Yeah that's wrong mate positive should only protrude about 1mm .as suggested above try to screw it in until only 1mm or so .is out past the threading
Okay just tried gently turning with a screw driver and it just turns the whole post, if it was going to push in it would have went when I screwed it on the istick?
Can it be pulled out ? Or screwed out .? .careful not to mark it in any way ...think your best bet is to take it back to the b and m you bought it from tbh
Looks like the insulator is too big to slip inside the 510 thread .in turn it is holding the positive out too far
I'm going to leave it alone and drop it back tomorrow, I don't want to mess and end up breaking something.
Sounds like a plan ...before you go .have a look at your other atties to see how much the positive pin sticks out .so you can check out the new one before you take it home .....
Unscrew the pin and see what's going on.. The insulator looks the right width to me. It may have two on or it may be a simple fix. It means you could use it now rather than waiting for a new one.