Dvarw 16mm thread

[rew]

I just got it in the mail. What diameter coil are you using? I usually wrap 2.5mm but it is so small that I'm thinking that 2mm would work better.

The air flow inserts on mine appear to be made of aluminum instead of steel. It's a YFTK clone. Do the Coppervape or Ulton clones have aluminum or steel air flow inserts?

I use 2mm ID in Dvarw 16. Works a treat. I have Ulton and Coppervape version and the inserts are the same as yours. Hi and welcome btw.

 

[Pericles]

I use 2mm ID in Dvarw 16. Works a treat. I have Ulton and Coppervape version and the inserts are the same as yours. Hi and welcome btw.

Thank you!

 

[Crewella]

I use 2mm ID in Dvarw 16. Works a treat. I have Ulton and Coppervape version and the inserts are the same as yours. Hi and welcome btw.

Coppervape on the way ......

 

[rew]

Coppervape on the way ......

Oooooo. Nice. I like the Coppervape silver. It is a satin finish rather than the polished look on the Ulton.

 

[Crewella]

Oooooo. Nice. I like the Coppervape silver. It is a satin finish rather than the polished look on the Ulton.

Me too.

 

[rew]

Me too.

Only thing to note is that the drip tip 510 cavity seems a bit shallow. I had real problems getting the Kamry stem to fit. Had to sand it down

 

[Crewella]

Only thing to note is that the drip tip 510 cavity seems a bit shallow. I had real problems getting the Kamry stem to fit. Had to sand it down

That Kamry stem doesn't fit properly in lots of my tanks ....... don't use it.

 

[rew]

That Kamry stem doesn't fit properly in lots of my tanks ....... don't use it.

Am using mine with a longish tip from a Heron clone at the moment until I can decide on another stem.

 

[decoy]

loving mine and it do seem that kanthal works better in it

 

[rew]

loving mine and it do seem that kanthal works better in it

What version is yours, or is it an original?