asmodus ANANI preview

[eyeball kid]

Just a preview of one in for review.

It's very kayfun prime on the deck but with a better coil post system.
The centre diffuser can be unscrewed to reveal a single hole around 2ml (possibly less).
This has top full via removable top.
Machining is perfect but it's ugly.
Tight mtl but no adjustment despite saying it is.
We shall see.

 

[Leni]

It could be the best attie in the world, but I will never know because it’s so ugly! I like Asmodus generally, just ... what were they thinking?

 

[MiscoDatt]

One of the reviewers referred to it as looking like a Lego piece. I think that was pretty spot on.

 

[Sharkymarky88]

Every time I see the word anani i think of this [emoji23][emoji23][emoji23]

 

[eyeball kid]

Design wise it's got so much right but visually. Oh dear.
The fugly parts are all replaceable so maybe they're plans.

 

[MiscoDatt]

Just a preview of one in for review.
View attachment 209188
View attachment 209189
View attachment 209190
It's very kayfun prime on the deck but with a better coil post system.
The centre diffuser can be unscrewed to reveal a single hole around 2ml (possibly less).
This has top full via removable top.
Machining is perfect but it's ugly.
Tight mtl but no adjustment despite saying it is.
We shall see.

Can’t you change out the centre pin?

 

[rew]

I would be embarrassed to take it out the house. So it's a no from me.

 

[eyeball kid]

Can’t you change out the centre pin?

It's threaded to reveal a 2ml hole. Again, seems like it's been designed with future spares in mind but like all chinese products. If it don't sell, they will drop accessories.
Basically the base and internal chimney are superbly built and designed for future improvement.
the tank, fill top and drip tip are awful looking and incredibly well made.
if it vapes as well as it should then I may be able to forgive the looks.
did it before with the enormous hulk that was the taifun gt 2.

 

[MiscoDatt]

It's threaded to reveal a 2ml hole. Again, seems like it's been designed with future spares in mind but like all chinese products. If it don't sell, they will drop accessories.
Basically the base and internal chimney are superbly built and designed for future improvement.
the tank, fill top and drip tip are awful looking and incredibly well made.
if it vapes as well as it should then I may be able to forgive the looks.
did it before with the enormous hulk that was the taifun gt 2.

Just looked like you could swap the pins out ala the spica. When you say tight are we talking .8 or 1mm tight?

 

[eyeball kid]

Just looked like you could swap the pins out ala the spica. When you say tight are we talking .8 or 1mm tight?

I've not run it with coil in place yet bud.
It's not going to be 0.8 tight and accurate measurements will be tricky due to the diffuser. Five holes but each pin small. We shall see.
Yeah it's threaded which points at future plans.