ax
Mod Maker
- Joined
- Feb 3, 2015
- Messages
- 654
So, I got asked to convert a 26650 Series box into an 18650 series box. Wasn't keen on doing it, as it's someone else's work, and I told the person who asked me to do it to leave as is. However on closer inspection, it was a bit janky in places, just a slight pull on the ground wire for the 510 made it come off the contact.
Before:
This was after I'd stripped it. Seems whoever put it together really liked epoxy and electronic varnish. About an hour with the Dremel and this was the result.
So I spent a few hours today after the few bits I needed arrived building it and this is the result:
One AxBox S v1 ready to roll out..
Before:
This was after I'd stripped it. Seems whoever put it together really liked epoxy and electronic varnish. About an hour with the Dremel and this was the result.
So I spent a few hours today after the few bits I needed arrived building it and this is the result:
One AxBox S v1 ready to roll out..
