Do you like Merlin MTL（mouth-to-lung vaping) ?

[Augvape]

Merlin MTL RTA, sizing at 22mm, a juice capacity of 3ml, and adjustable airflow system of 3.5mm, 2.5mm, 2mm, 1.6mm, and 1.2mm. Airflow can be changed internally with air plugs and can be set from increments of 1.2mm, 1.6mm, 2mm, 2.5mm, or completely open at 3.5mm. The build deck size is 7mm to accommodate small builds that are typically used for mouth-to-lung and two 9mm wicking ports are available to saturate the cotton. Along with the small build deck, coils are held down by two hex screws, under are two additional hex screws and can be adjusted for additional internal side airflow. Airflow enters the Merlin MTL on the bottom via dual adjustable airflows that sizes at 7mm by 1mm each side and can be fully closed. Juice enters the Merlin through two 10mm by 2.5mm juice slots located on the top. The Merlin utilizes two drip tips, a 510 delrin drip tip with a 11mm bore and a 510 stainless steel mouth-to-lung drip tip with a 3mm bore.

Specs:

• 22 mm Diameter
• 3 mL Capacity
• 304 Stainless Steel Construction
• Dual Block Post Deck Design
• Threaded Top Fill
• 22 x 43 mm with 510 Drip Tip
• 22 x 54 mm with MTL Drip Tip
• Changeable Airflow Plug Diameters (1.2 mm, 1.6 mm, 2 mm, 2.5 mm, 3.5 mm)
• Side Airflow Grub Screw Adjustment
• Bottom AFC ring
• Stainless Steel MTL or Wide Bore 510 Drip Tip Options

Kit Contents:

• 1 x Merlin MTL RTA
• 1 x Spare Glass Section
• 1 x Stainless Steel MTL Drip Tip
• 4 x Air Plugs
• 1 x Spare Parts Kit
• 1 x Manual

 

[zippydodah]

I preferred the juice flow control on the first version merlin when compared to the later ones, its almost as if it doesnt stop the juice flow completely. It might just be mine, but its a real shame as it had the potential to be a great