ScottishDuck13
Postman
- Joined
- Mar 7, 2017
- Messages
- 472
Hi guys,
I usually use only rebuildables for the last few years but just wanted a small handheld device so I got the Drag X as it looks so damn nice and got the RTA deck pod with it. So far I have tried 3 different coils/builds and cannot get it to work properley and today have just realised why. When I have the VM1 stock coil in, its 0.3ohms. When I swap it over to my RTA pod, it still reads at 0.3ohms. I have put multiple builds onto ohm readers and DNA devices, all read them accurately, the latest one is 0.45ohms.
When I add the 510 adaptoer and use the pod on my DNA mod, it reads at 0.45 and vapes as it should, however remove from there and put back on my Drag X and it reads it at 0.3 again?! Its like its stuck with what the last stock coild read at.
I have turned it off/on, changed batteries, cleaned the connections, made sure nothing looked out of place and even tried re-doing the Firmware update even though I did that the day I got it.
Right after the firmware update it finally read my RTA pod at 0.45, but then I took it off, put it back on and its back to 0.3?! I sat for 5mins just pulling the pod off/on to force re-reads and once during the whole time it read at 0.45 like it should.
I have to say the first stock coil I tried on it (the VM6 was surprisingly fantastic!
Any ideas guys?
I usually use only rebuildables for the last few years but just wanted a small handheld device so I got the Drag X as it looks so damn nice and got the RTA deck pod with it. So far I have tried 3 different coils/builds and cannot get it to work properley and today have just realised why. When I have the VM1 stock coil in, its 0.3ohms. When I swap it over to my RTA pod, it still reads at 0.3ohms. I have put multiple builds onto ohm readers and DNA devices, all read them accurately, the latest one is 0.45ohms.
When I add the 510 adaptoer and use the pod on my DNA mod, it reads at 0.45 and vapes as it should, however remove from there and put back on my Drag X and it reads it at 0.3 again?! Its like its stuck with what the last stock coild read at.
I have turned it off/on, changed batteries, cleaned the connections, made sure nothing looked out of place and even tried re-doing the Firmware update even though I did that the day I got it.
Right after the firmware update it finally read my RTA pod at 0.45, but then I took it off, put it back on and its back to 0.3?! I sat for 5mins just pulling the pod off/on to force re-reads and once during the whole time it read at 0.45 like it should.
I have to say the first stock coil I tried on it (the VM6 was surprisingly fantastic!
Any ideas guys?