What's new

New to RTA No Coil error

fryer2000

Initiate
Joined
Jan 10, 2014
Messages
20
Hi guys noob here! Apart from trimming back the wire. Can anyone see what I’m doing wrong???
IMG_0119.JPG
IMG_0120.JPG
IMG_0121.JPG
 
Nothing wrong with that coil just make sure your screws are tight take your atty off that mod fire the mod without it then put it back on and try again [emoji6]
 
Seriously,

Looking at the state of it, I’d say you don’t have a sufficient 510 connection.
 
Also. That doesn’t look like Kanthal.

What’s the lowest resistance the mod will run at?
 
0.2 and 0.4 is what I’ve been putting through it using cleito and Q2 coils. The coil on the build is what came with it
 
I’m going to go with my first thought that there’s no connection between the deck and the 510 pin.
 
So after playing around. Turns out the little rubber piece holding the pin in the base was the wrong way round! [emoji85][emoji85][emoji85][emoji85]

All wicked and juiced up! Vapes a treat [emoji1303][emoji1303][emoji1303]
862EBE93-B44A-4C04-BCEC-F32E3ACE89A1.jpg
 
Back
Top Bottom