First rba build

[markmark]

Well I attempted to rebuild my ego one rba tonight I got some 26g wire and was aming for 0.5 the first on I built is 0.83ohms and the second if 0.72ohms

What do I have to do to get to 0.5ohms sorry for the stupid question but I am brand new to all of this

 

[johnnylager]

Not familiar with the ego one, but Steam Engine says 4 wraps of 26G at 2mm for 0.5 ohms http://www.steam-engine.org/coil.asp?r=0.5&awg=26&id=2

I found 24G easier for a 0.5 ohm coil - 5 wraps at 3mm http://www.steam-engine.org/coil.asp?r=0.5&awg=24&id=3

 

[fugee]

This calculator works for me every time. Saves doing all the maths!

http://www.steam-engine.org/coil.asp

 

[markmark]

Ahhh right that's what I have done wrong I done 5 raps cheers

 

[Crewella]

Yep, try one with everythiong else the same but a wrap less. It's not long since I did my first coil - such a sense of achievement! Good luck!

 

[2minvapereviews]

Ahhh right that's what I have done wrong I done 5 raps cheers

Make sure you always use a calculator in the future, going to save you so much time and hassle, plus it's a lot safer when you're starting out.