What's new

Engine II RTA - ohms too low?

I'm no expert on this but if you put dual 0.2 ohm coils in they are gonna come out at 0.1 ohm overall. Would you really want to go that low anyway?
 
mod reads at 0.04ohm then displays error
The only explanation for it is your coil is touching something it shouldn't be or you have a piece if wire inside your deck from clipping your leads so take a coil out check for random bits of wire and see what 1 coil reads at
 
If there is a flat head screw in the base of your 510, try giving it a tighten.
 
Check the resistance without the chimney fitted
Possibly shorting with the chimney part

If it's still too low try removing the coils completely and check resistance again
Should give you a check atomiser error

If not you have a short on the deck somewhere.
 
Don't know the ID of the coil, but a quick check on steam engine would suggest each coil should be approaching 0.4 ohms, giving circa 0.2 for the pair. Definitely something shorting.
 
finally got it up and running without errors, but something still not quite right, as it’s reading 0.11ohm for the pair... ?!
 
Back
Top Bottom