What's new

Ahhh that’s better x

I was following this, to see if I could help, but got a little confused. Did you use 0.32mm or 32 AWG Kanthal? Because 0.32mm is 28 AWG, i.e. what Crewella uses.

This is the best supplier for plain wire - https://www.stealthvape.co.uk/product/kanthal-a1-wire/

But if you feel like experimenting, there is always the more modern complex coil wire for MTL - an MTL fused clapton. These are usually either made using Stainless Steel or Nichrome Ni80.

Like these options:

https://bitandpiecesvape.co.uk/shop/accessories/premade-superfine-mtl-fused-clapton-coils/
https://www.cremedevape.com/Vandy-Vape-Superfine-MTL-Fused-Clapton-Wire
 
Errrrrr ummmmm image.jpg
 
Experiment you say , I will be x I was kindly given some pre made coils with all the tanks, so will be using them at some point x
 

Ahh, good ol' Crazy Wire Co.. guaranteed to confuse.. it says .32 so it's *probably* 28 gauge. (Crazy Wire Co were known to sometimes mislabel stuff too, so..)

You said 6 wraps. What inner diameter did you use and what did it come out as, resistance wise? If its like 1.0 - 1.4 ohms, its 28 gauge already.
 
Last edited:
Ahh, good ol' Crazy Wire Co.. guaranteed to confuse.. it says .32 so it's *probably* 28 gauge. (Crazy Wire Co were known to sometimes mislabel stuff too, so..)

You said 6 wraps. What inner diameter did you use and what did it come out as, resistance wise? If its like 1.0 - 1.4 ohms, its 28 gauge already.
Between 1 and 1.2 ohms and errr a drill bit lol………………. Sorry
It had no size on it so had to hunt around, it was a 2.5 I believe x
 
Back
Top Bottom