53mm RDA

[Andy S]

I hadn't heard of it so I Googled it and I have to admit I'm tempted. I like the fact that you can remove some of the posts to make more room for fewer big coils instead of lots of little ones. The barrel seems pretty short so it would be interesting to see what the air flow is like with all eight in there. Not sure I want the coils that close to my mouth but unless someone can cure my shinyitis I may give it a go.

 

[MiscoDatt]

This?

 

[zouzounaki]

 

[mattyk2010]

I hadn't heard of it so I Googled it and I have to admit I'm tempted. I like the fact that you can remove some of the posts to make more room for fewer big coils instead of lots of little ones. The barrel seems pretty short so it would be interesting to see what the air flow is like with all eight in there. Not sure I want the coils that close to my mouth but unless someone can cure my shinyitis I may give it a go.

Can you answer my earlier question please bud? Where have you seen the HOG wired in series or parallel and not both? And do you have a link?

 

[joe clay]

Can you answer my earlier question please bud? Where have you seen the HOG wired in series or parallel and not both? And do you have a link?

Hes only 20yrs old so hope he hasn't just got into vaping and just thought hahaa thats a big fuck off monster, i'll have that, and NOT have the vaping experience and knowledge of ohms law and battery safety, i shudder to think

FUCK i hope i'm wrong

 

[mattyk2010]

Hes only 20yrs old so hope he hasn't just got into vaping and just thought hahaa thats a big fuck off monster, i'll have that, and NOT have the vaping experience and knowledge of ohms law and battery safety, i shudder to think

FUCK i hope i'm wrong

I hope so too that's why I wanted clarification [emoji20]

 

[vapesmarter]

I’ve made mods to suit a 53 mm Atty but the amount of power going through that mod is just silly

Why do you want a mod that can take a 53mm attys i can understand power and shiny stuff

 

[Jesse Crumpton]

I recently bought the Vapergate Colorado RDA which is 52.8mm in diameter.
I'm looking for advice on what route i should take on getting a mod to suit it. I have done some shopping around and i'm still unsure on what would work.
Any advice is appreciated.

I have mine sitting on a hammer of god v4. There's a slight over hang cause the top is tsppered in. I'm running 8 coils @.28 ohms which has a long ramp up time..28 ohm is pretty low in my opinion for this mod.ill try to upload a picture for you to see the two together.