Connection Pin issue

[Smokeandsteam]

Could do with some advice guys. I think I’ve pushed my connection pin down into my Billet Box. Must be cranking down too much?. Ive had problems all weekend with the resistance jumping all over the place and regular ‘check atomiser’ warnings. I’ve had a proper look tonight and the pin looks flush with the bottom on the device and iirc it should be slightly raised by about 0.5mm. Gutted

Any advice or help? I can’t be the first to make this stupid mistake?

 

[rew]

Wouldn't even attempt to give advice on this but hopefully @domejunky can offer some.

 

[Smokeandsteam]

 

[Smokeandsteam]

@rew thanks. I’ve got no idea either. I’m going to try a Qbix and a few different bridges today but I’m fairly sure the pin has sunk due to over cranking by me.

 

[rew]

@rew thanks. I’ve got no idea either. I’m going to try a Qbix and a few different bridges today but I’m fairly sure the pin has sunk due to over cranking by me.

Hope it works for you mate.

 

[Vapaneezer Scrooge]

The only way I can think to remedy this is by placing a tiny O-ring around the lip of the copper pin, it needs to be pretty small though, you should be able to scavenge one from the top of a small stock coil, the photo below should give you an idea of where it goes.