Cleaning tube mod

[Deleted member 54254]

I'm not convinced by that, I'm looking at this on one of mine...

 

[Zited]

I'm not convinced by that, I'm looking at this on one of mine...

View attachment 232473

Oh jesus... Well that's not good see the thing is I brung it out a bit more earlier but then it wasn't reading the atty so I had to screw it back in to where it is now, what's should I do then

 

[Zited]

I assume I should stop using the rda on the mech then. Shame it's my only rda atm broke my other one

 

[Deleted member 54254]

Does that distance look at least 2mm?

 

[Zited]

View attachment 232475


Does that distance look at least 2mm?

I'm terrible with lengths lol but if I'd have to say I'd say that's like 1mm

 

[Deleted member 54254]

You don't want the battery getting dented and bridging from the positive pin onto the negative thread or bad things happen, real quick, your call to make.

 

[Zited]

You don't want the battery getting dented and bridging from the positive pin onto the negative thread or bad things happen, real quick, your call to make.

Well in that case I don't know what too do I'll just try and bring the pin out a bit more and hope for the best

 

[Zited]

@John R what about this? I think I had the wrong 510 pin in

 

[Deleted member 54254]

Looks fine to me bud.

 

[Zited]

Looks fine to me bud.

Sweet let's see if the build works fine thanks again for the help I didn't realise you could end up using the wrong 510 pin hahaha