Plug squonk hole?

[Jerri]

I bought a wasp nano second hand and it didn’t come with the spares. Only realised when I went to build it that the 510 pin installed is the squonk pin. I don’t own any squonk mods.

Can’t find a replacement anywhere besides FT but is there anything I can use to plug the pin whilst I wait an unknown amount of time for the pins to arrive from FT?

 

[tony68]

Bit of rolled up tissue paper stuffed in nice and tight works well or even some cotton.

 

[andyroo]

I’ve used a cocktail stick sanded to fit tight before but you need to keep an eye out in case it leaks.

 

[Jerri]

Bit of rolled up tissue paper stuffed in nice and tight works well or even some cotton.

I’ve used a cocktail stick sanded to fit tight before but you need to keep an eye out in case it leaks.

Thank you both!

 

[gary68]

Thank you both!

How bout the end of a birthday candle holder. Should be small enough

 

[Jerri]

How bout the end of a birthday candle holder. Should be small enough

Good shout! Will see if I have any.

 

[fil]

PFTE tape, heat proof foodsafe and virtually inert, use a coctail stick or similar pointer to ram it in