Ohms Jumping Help!

[JEmpire]

I have Kensei RTA sitting on the new Snow Wolf X-Feng.

Currently I have Juggernaunt 2.5 ID, 5 wraps.

When cold, it hits 0.15 but it seems like the higher I turn the wattage up, the higher the ohm goes.

It's on 76w, reading 0.15 but when i fire the button long press, it changes to 0.19. When i do short fire press, iti slowly changes to 0.22.

I'm not too sure what's happening. Coils aren't touching anything - I've checked the 510 thread connection.

Any suggestions?

 

[nwhornet]

If it's SS or another TC wire, perfectly normal. Even non TC wire will change resistance when heated.

 

[Simon G]

I have Kensei RTA sitting on the new Snow Wolf X-Feng.

Currently I have Juggernaunt 2.5 ID, 5 wraps.

When cold, it hits 0.15 but it seems like the higher I turn the wattage up, the higher the ohm goes.

It's on 76w, reading 0.15 but when i fire the button long press, it changes to 0.19. When i do short fire press, iti slowly changes to 0.22.

I'm not too sure what's happening. Coils aren't touching anything - I've checked the 510 thread connection.

Any suggestions?

that's not called 'ohms jumping' that's called 'wire getting hot'

 

[SirLugg]

And to echo the two gents above the Laisimo boards are live resistance readers.

Tl;dr Nothing to worry about. [emoji6]

 

[JEmpire]

Thanks everyone.

I was just a little confused as my SS staircase and SS Fused didn't do it. It's just been with the Juggernaut and the Super Juggernaut. So I got a little worried.