POTV - Your vaping community

Wanting to join the rest of our members? Why not sign up today!

Register

Genny style atty woes

Discussion in 'Rebuildable Mods and Devices' started by Seedy, Nov 25, 2013.

  1. Chegs

    Chegs Veteran

    Joined:
    Sep 15, 2013
    Messages:
    5,923
    Likes Received:
    1,000


    Just a quick video to let you see what that coil/wick I posted earlier can do :)
     
    #31 Chegs, Nov 26, 2013
    Last edited by a moderator: Oct 23, 2015
    • Thank Thank x 1
  2. Seedy

    Seedy Vendor

    Joined:
    Oct 29, 2013
    Messages:
    3,271
    Likes Received:
    627
    I just tried this method and it's much better.
    I got about 40mm square of 400SSmesh, cut about a 3rd off. Oxidised both bits, rolled the small bit into a pin and the other bit around a 2mm nail. Oxidised again and then put the pin inside the mesh tube.
    4 wraps of .2 comes out at 1.6ohms.
    It vapes alot better.
    It was a bit tight on the Aga as I think the hole is slightly smaller than the RSST. I'll vape it for a while and see how I get on. Without pulling my wicks out of these 2 attys, I think the RSST has a slightly bigger hole so I am considering drilling the wick hole on the Aga T2. Does anyone know the sizes of these 2 holes?

    Thanks again to everyone for your help.
     
    #32 Seedy, Nov 26, 2013
    Last edited by a moderator: Oct 23, 2015
  3. Seedy

    Seedy Vendor

    Joined:
    Oct 29, 2013
    Messages:
    3,271
    Likes Received:
    627
    Well I'm half a way through a tank of juice and its all good. Happy Genny user right here :-)
     
  4. Mawsley

    Mawsley Putting the soup into super hero

    Joined:
    May 14, 2013
    Messages:
    23,654
    Likes Received:
    13,591
    I've taken both of my T2s out to 1.5mm

    The RipTrip cotton-headed mesh works SO well I don't even bother flaming or compacting the coil now. Seven or eight wraps of .3 gives me around 1.2ohm and a genius vape. Never a hot spot, never a dry hit, just plain great hits.
     
  5. Seedy

    Seedy Vendor

    Joined:
    Oct 29, 2013
    Messages:
    3,271
    Likes Received:
    627
    I'm talking about the wick hole Mawsley. I've already drilled out the airhole to 1.5 but I think the wick hole could be bigger.
    Saying that, I just measured the RSST and the T2 and they are both 3mm. I wonder if anyone has tried drilling it out and putting in a wider wick?
     

Share This Page