Dripper for pipes

[Jon The Vape]

Here's the 18mm Ambition mods Spiral mtl RDA.
Arrived today from Fasttech.

Smallest airflow is a tight mtl draw, flavour very good.
More thoughts as I find it.

 

[zouzounaki]

It looks interesting. Where does the air come in? Is it smooth?

 

[rew]

Love the look of this Jon

 

[Jon The Vape]

It looks interesting. Where does the air come in? Is it smooth?

Bottom airflow and it's smooth so far [emoji4]

 

[Jon The Vape]

Deck shot, from 3f vape.

 

[bellyman]

I like the lok of the deck but I'm always nervous of leakage with dippers on a pipe.

 

[Jon The Vape]

I like the lok of the deck but I'm always nervous of leakage with dippers on a pipe.

I'm going to check out the leak factor overnight [emoji4]

 

[MiscoDatt]

compliments the pipe perfectly.

 

[Jon The Vape]

Left on a stand at 45 degree angle no leakage. The top cap is a good seal to the extent I can pick the pipe up by the stem and no fear of dropping the lot through the cap sliding off.
I have not overfilled yet but to say how small it is the juice well is good.
Need to have a read up on you tube for reviews, as it's been out some time. [emoji4]

 

[Jon The Vape]

I like the lok of the deck but I'm always nervous of leakage with dippers on a pipe.

I'm the same, but heard good things of this one. Machining is spot on and dropping a 2.5mm 26 or 28 gauge coil in is a doddle.
I thought because of the size it might be a faff.