What's new

SXF Prime kit essentials?

Clouded

Postman
Joined
Jan 29, 2017
Messages
228
I'm just about to purchase an SXF KF Prime clone from FT and I'm looking for some advice as this will be my first MTL RTA.

I need advice for the following if possible:

What should I buy to build my own coils? Coil winder?

What wire type/thickness works best?

Anything else you can recommend for first time builders?

I have built on my RTA before but this was on a aspire tank where I used 26g kanthal and made simple coils using a precision screwdriver so it wasn't anything special.

Cheers
 
Coil master from ft
I use n80 wire and ss both again available from ft. 26 awg is good.
 
Coilmaster v4 coil building kit is handy if you already own all the other bits like snips, scissors, ohms reader, ceramic tweezers etc.
 
The 26AWG is good, a screwdriver and some cotton and you're good to go. You can always add to the list as you go along.
 
Cheers for the advice everyone, going to get that tank and a Hastur Mini MTL RDA :)

And of course the cutters haha!
 
The KF is a great atty, I have two of them. A little fiddly to put a coil in, as there is not a lot of room. Great flavour and lots of air flow options.
 
Back
Top Bottom