Kayfun lite 2019 build

[Younoowho]

Looking for some advice guys, I vape manabush firewater no1 as a adv, just got a kayfun lite and can work out the best build for the juice, what does everyone use? I’m on a 36awg ss 5 wrap spaces around a 2.5 Id and I’m not getting the flavour and performance I’d expect from firewater on tc or wattage mode on my dna75c, anyone recommend a build for me? thanks in advance
Benji

 

[rew]

I generally use 27 awg kanthal, 2.5mm ID, 7 wraps @ 1.1 ohm. Vape it between 13 to 15 watts.

 

[MiscoDatt]

Got 6 wraps ni80 28g just under 1 ohm slightly spaced. 17 watts

 

[Chris K]

Got 6 wraps ni80 28g just under 1 ohm slightly spaced. 17 watts

Exactly the same build except I don't space mine.

Flavour is very good.

 

[shale84]

I have 3 kayfuns lite,using nife30,6-7 wraps,2.5 id, slightly spaced,0.25 ohm 12W,220C
Best flavour/vapour of all the atties I have/had(and I had almost all of them MTL out there)
Don't pack too much cotton into slots,but make sure it's going deep enough

 

[Deleted member 54254]

NiFe30, 6wraps spaced 2.5ID, use Replay it's a DNAc

 

[Younoowho]

Thanks so much guys for the feedback, might try the ni80

 

[eyeball kid]

Never got on with nichrome in mtl rta 's myself. Heats so quickly it burns me bush (ooh er).
kanthal 27 (26-28awg is fine) 7wraps and 2.5mm. No spacing for me.
Stainless is great for a day then it coats so it's a coil change. Nichrome used to be ok back in the day when mods where a tad slow on the uptake, lol.

 

[MiscoDatt]

Never got on with nichrome in mtl rta 's myself. Heats so quickly it burns me bush (ooh er).
kanthal 27 (26-28awg is fine) 7wraps and 2.5mm. No spacing for me.
Stainless is great for a day then it coats so it's a coil change. Nichrome used to be ok back in the day when mods where a tad slow on the uptake, lol.

Ya big girls blouse.

 

[shale84]

Fresh coil inside
I tried alot of temp control wires and stealthvape nife30 is best for me