Airflow reduction using mesh

[Mohamed]

Thanks guys for the replies, I just wanted to make sure I'm not doing something terribly wrong before going ahead with a test

 

[zouzounaki]

I’ve had good results with it in a few different devices @Mohamed . Takes a bit of trial and error to get just the right restriction.

 

[eyeball kid]

Sorry not the chimney, bad wording on my part. The airflow under the coil. A couple of atomizers actually, old ones that I don't use anymore since I've been using the Dvarw exclusively for the past year, atties like skyline (doesn't have a reducer up to 1.2mm), berserker v1 mini

The skyline has a 1mm single hole airdisc direct from esg for about a fiver.
If your using a coppervape clone they fit like a glove.

 

[Mohamed]

The skyline has a 1mm single hole airdisc direct from esg for about a fiver.
If your using a coppervape clone they fit like a glove.

I didn't know that, I will check it out

 

[eyeball kid]

I didn't know that, I will check it out

It's a beautiful rta. Really so well made. Mine is a clone and I often use it with the mini pei top. The thing is I think it shines at wide open mtl/restricted dtl (for my tastes) used the small insert for ages and fiddled around with coils trying to get what I wanted before I realised that like the rose v3 it just works better with a little sub ohm coil and some airflow.
I keep the hastur minis and kayfun lites for mtl.