What's new

Building a nextgen clone - HELP!

jj87

Postman
Joined
Dec 16, 2015
Messages
794
Hi can anyone help me with building my nextgen clone, every time I build it it's fine for at least a day then the ohms start jumping all over the place anywhere from 0.97-1.52? I can build my nextiny's with no problem but this is driving me nuts (& also loosing good juice!) I have re wrapped it several times but same thing happens? Any help much appreciated before I cut my loses with it. Thanks
 
Is there something shorting? Either inside between the pole and base or with the 510?
Also check your coil screws
 
Is it a sxk clone, they are great a different one from China was a bag of shit and couldn't get a build on it.
Hope you sort it:)
 
What you will find if the mesh sits flush at the bottom u will get problems like
Shorting and issues with resistance. Just pull it up a bit
 
Back
Top Bottom