Vape Club
What's new

Athea In'ax MIII Build Thread

kaplan

Achiever
Joined
May 10, 2015
Messages
1,453
Just wanted to share one of my builds in my In'ax.
Not to shabby for a first build but I have been practising on clone gens.
I have been vaping this well over a week and just gave its first clean.
It is the official MIII build, 40x20 200sf with 10x7 300 topper.
.30, 4 wraps, currently sitting at 0.78
Image1461448130.333905.jpg

Image1461448146.213637.jpg

Image1461448163.335217.jpg

Image1461448174.391774.jpg

I got videos for ramp up and vapour production but can't seem to upload from my IPhone.
 
Smoore
AcmeFog
Nice build!

I use 200sf, 20mm height x 30mm diameter, with a 10x10 300 topper, 4 wraps of .3mm for 0.8ohm. Works a treat at 25-28w.

Might give the official build a go next time around ;)
 
Innokin
Looks great, and very helpful for a noob like me, thank you.

I note that so many mesh builds I see are with spaced coils rather than micro coils, are they better for mesh?
 
Nice build!

I use 200sf, 20mm height x 30mm diameter, with a 10x10 300 topper, 4 wraps of .3mm for 0.8ohm. Works a treat at 25-28w.

Might give the official build a go next time around ;)
Very similar builds but I didn't go as high as 25W, I have to try that.
 
Vape Green
Back
Top Bottom