Worried about low ohm reading

[DMAN]

I'm new to this rebuilding lark, so go easy.
I stuck in a couple of pre-made coils that came with the Crius, and it is reading 0.05 on my ohmreader. I stuck it on a mod to double check.
That can't be right, can it?

 

[sganatra]

Try tightning the 510 pin. Mine came out at 0.3

 

[DMAN]

I never made myself clear. It is ok before I stick the deck in the tank (0.53). When assembled it reads 0.05. I reckon it might be a short caused by not trimming the wire close enough to the post?

 

[DMAN]

It reads 0,28 on my D2, 0.35 on my mini VTC and now reading 0.44 on the ohms reader!

 

[DMAN]

It was that pesky wire sticking out. Cheers.

 

[DMAN]

Mmmmm. Nice.