What's new

I Demand Coil Porn!!!

But the vape is shite...
20171214_144736~3.jpg

Waist of time...
 
IMG_20171218_185415.jpg

So far... Best flat braid I've done to date. Finally tight and consistent. (Ignoring the obvious mistake near the bottom.) Somewhere along the line I lost a wire, which sucked, but I just kept going
IMG_20171218_185755.jpg
 
I made my very first coil on the 26th, the wicked cotton one. And the 27th I made a parallel which I was happy with.

Both vaped very nice and I'm looking forward to the more advanced stages of coil building
20171226_173304.jpg
20171227_152251.jpg
 
IMG_20171231_193727.jpg

Wanted to go a completely different route with this, but it was an epic fail. There was flat ribbon in the center, but I couldn't get it to lay right when I wrapped a coil from it. So I just pulled the wire out from the center and then rolled the edge of a wire spool down the center to flatten and spread the two remaining staggered Claptons.
IMG_20171231_194110.jpg

Even though it wasn't my original thought, I really like the way this turned out. Measures at .33
IMG_20171231_204947.jpg

26g nicgrome stagger wrapped with 30g nichrome. Four 26g wires in-between stacked two on two (for spacing, later removed). Then wrapped all together with 36g kanthal.
IMG_20171231_205332.jpg

And for S.A.G.s.......
IMG_20171231_205212.jpg
 
Last edited:
A bit wonky.
3x30g+38g clapton Ni80, paralleled with 25g Kanthal.
Not made for Instagram, made to chuck a lot of vapour in my gobhole.
0.25ohm in the Armageddon Elite gen 2 sat on a HOG V2.

mir_20180105_143638.jpg
 
So this is my dual core stitched alien, 2*26g core, 32g into a 34 then wrapped.

I failed at building an alien before this, so I'm super impressed with myself. Entered this into coil wars I was that happy with it. Nowhere near perfect, but for my 6th or so build I'm ecstatic
20180121_002555.jpg
 
Finally managed to make my 1st (semi) successful baby alien, went a bit wonky in places but I just about managed to salvage enough for a single coil...
SS316L 2x0.29mm cores wrapped with 0.14mm
IMG_0376.JPG
IMG_0377.JPG
 
Back
Top Bottom