If so, then I need your attention for a moment. I've been using stainless since the beginning. It's what I first with because of the flavor compared to A1. Anyway, I was wondering or hoping some had a way of being able to increase the resistance of the build. My problem being that I use dual coil setups. I built a dual parallel coils using (28ga+32ga)*24ga+0.1*0.5 super juggernaut 316L Stainless. But yeah, barely any resistance...though you can tell I was able to get some heat to them for a break in. This same build done in a single wrap instead of parallel hits in a beautiful range for my preference in TC gaping. Any thoughts or options would be much welcomed. Vape it up!