Vapaneezer Scrooge
Vendor
- Joined
- Dec 23, 2017
- Messages
- 6,128
Spent 4 hours fault finding and managed to fix an Wismec RX2 Jaybo 20700, I was feeling pretty chuffed with myself I popped it back together only to find the 510 thread is cross threaded near the top
I've tried all I can to clean the thread but I need a tap.
Found one on fleabay but not sure which to get, my options are:
Plug
2nd
Taper
Leaning towards the PLUG as it looks useful for cleaning up threads, I can strip down the mod again to get a clear hole but I know some mods can be a bitch to get a clear bore.
So I'm after experienced advice which will be most useful?
The 2nd tap looks more useful but not sure if it will bite on a cross threaded connector?
I've tried all I can to clean the thread but I need a tap.
Found one on fleabay but not sure which to get, my options are:
Plug
2nd
Taper
Leaning towards the PLUG as it looks useful for cleaning up threads, I can strip down the mod again to get a clear hole but I know some mods can be a bitch to get a clear bore.
So I'm after experienced advice which will be most useful?
The 2nd tap looks more useful but not sure if it will bite on a cross threaded connector?