Ethendinythor
Postman
- Joined
- Jan 25, 2017
- Messages
- 300
I'm in the planning stage of a project for a single 18650 squonker.
Plan is for 1 piece (plus door) milled from a solid piece of unstabilised rippled sycamore left over from a guitar.
First concern is the thickness of the walls needed, would 5mm be enough?
Anyone had any experience using unstabilised wood?
Plan is for 1 piece (plus door) milled from a solid piece of unstabilised rippled sycamore left over from a guitar.
First concern is the thickness of the walls needed, would 5mm be enough?
Anyone had any experience using unstabilised wood?