mosfetius
Postman
- Joined
- Jan 27, 2017
- Messages
- 104
Had an off cut of Afzelia burl and Cocobolo and thought I'd try and make a mod out of it so I built this tiny little 18350,
Drilled the stealthvape tube at a diagonal and mounted my DuFet Dual mosfet pcb between the tube and modded switch that uses my tactile switch pcb,
Had to rethink the modmaker 16mm 510 position after it was going to sit too low on the opposit side as it is now though I ended up making a feature of the originally intended side by side recess and relocated to where it is now,
Approx size if the mod not including the protruding tube is 50x40x23mm
Drilled the stealthvape tube at a diagonal and mounted my DuFet Dual mosfet pcb between the tube and modded switch that uses my tactile switch pcb,
Had to rethink the modmaker 16mm 510 position after it was going to sit too low on the opposit side as it is now though I ended up making a feature of the originally intended side by side recess and relocated to where it is now,
Approx size if the mod not including the protruding tube is 50x40x23mm