Help with wiring needed

[shale84]

Hi apes
I have board from Think vape Thunder (dna75c clone) that I want to install in custom mod with 2x 18650 wired in series,I took board out of the mod ages ago and I cant remember how it was wired and I cant find anything on the net.
Any help would be appreciated
Thanks

 

[nwhornet]

Try pming Rob @stealthvape . If it's a genuine 75C board he should be able to point you in the right direction. Not heard of Thinkvape using fake Evolv boards though.

 

[Vapaneezer Scrooge]

Can you post a photo of the board?

Is it a 'proper' clone controlled by 3 buttons for the menu and 1 fire button?

If so it's piss easy, positive & negative from the battery to the base of the board, then positive & negative to the 510 connections (positive to base negative to top), the board should have + and - marked.

 

[shale84]

It's not Evolve board, that's the issue

 

[shale84]

Like this?

 

[vapesmarter]

yes

but, careful of those wire gauges that is a lot of amps going to the board

 

[Shetland Sam]

yes

but, careful of those wire gauges that is a lot of amps going to the board

Would a red Sharpie pen handle the amps better?

 

[vapesmarter]

Would a red Sharpie pen handle the amps better?

the blue looks a bit 32 gauge may be a bit thin but I know at least shale won't wire the negative to the case so many mods manufacturers do these days

 

[shale84]

Thanks for help @vapesmarter,I'm usually using 16 or 18awg but I like small form single 18650 mods and I never go above 20 watts.I think I'll go 14awg here as this is going to be a gift so I want to be sure that it's safe

 

[shale84]

It's not working this way,must be some catch