What's new

Hana DNA40 build thread High Voltage Box Mods style :)

didn't even think about the switch size until I looked at your build.

Am planning a hana box build with either a fat daddy or varitube 510 and was going to use this switch

16mm Nickel Plated Brass Momentary Push Button Switch

as it is not very deep so thought it would help with the limited space. just not sure If the hole required to take the switch would be too wide for the box.

Also which 510 would you recommend the FDV or the vari ?

FDV is better, the positive pin gets its stability from brass bottom ring that you screw on, Varitube is using the nylon washer. FDV spring is much better and has a o-ring to stop juice from leaking threw the 510.
 
FDV is better, the positive pin gets its stability from brass bottom ring that you screw on, Varitube is using the nylon washer. FDV spring is much better and has a o-ring to stop juice from leaking threw the 510.

Great thanks for the advice. Just need to get a m10 x 1.0 tap now .

Also still undecided on the switch really like the 16mm one but a bit worried that the 16mm hole required will be too big and that the 18mm bezel will overlap the back plate
 
Great thanks for the advice. Just need to get a m10 x 1.0 tap now .

Also still undecided on the switch really like the 16mm one but a bit worried that the 16mm hole required will be too big and that the 18mm bezel will overlap the back plate

No problem

Think a 16mm will be a squeeze.
 
20141028_220725_zps069c7b2f.jpg

20141028_220545_zps3b5df9b4.jpg

20141028_220539_zps0911945b.jpg
 
Cheers for the picks, think my mind is made up. FDV 510 and non illuminated 12mm switch. Thanks for all the advice BaDaBooM..
 
Back
Top Bottom